Simple Gems
by Peter Moore
Summary These are some gems I made, I've printed some of these up to 5 inches across. Most can be...
Phone hanger
by Peter Moore
Summary Just a couple of phone hangers I made for my wife to hang her phone on the high up cupboa...
Kitchen sink drain hole replacement
by Peter Moore
Summary This is a replacement part for a kitchen sink. It should fit a 42mm plug and fits into a ...
Cosplay light up ring
by Peter Moore
Summary This was made for a Panto in the UK, There is space inside the hollow gem to take two led...
Personal Apprentice replacement legs
by Peter Moore
Summary This is a replacement leg for a toy robot my son was given as a present. Unfortunately bo...
Gazebo 3 and 4 pole replacement parts
by Peter Moore
This repair part was done for a friend. I've updated to include a 3 pole part, These are made fo...
'Brother Scan n Cut' Side storage boxes
by Peter Moore
These are a couple of tool storage boxes I made to fit various parts. The boxes were stuck to the...
HICTOP Prusa i3 Y axis idler pulley mount (added radiused corne
by Peter Moore
Summary I've updated this a little with the edges radiused which should reduce belt rubbing, and ...
Linear Bearing holder IGUS compatible, updated!
by Peter Moore
Summary I've updated this to make it compatible with my IGUS drylin bearings. I've added three mo...
V-Block
by Peter Moore
Summary This is a simple v block, I designed it for using to saw tubing. To prevent it sliding ar...
Hictop carriage cable support
by Peter Moore
Summary I'm currently trying out a Bowden extruder on my. Hictop aluminium and previously the hot...
Brother Scan N Cut CM300 Storage box with lid
by Peter Moore
Summary I've added a slightly deeper box with different partition spacing to hold larger tools. T...