Behold! The State of Michigan's lower peninsula! Any fellow Michiganders here on pinshape?

I'm new to 3D printing, so my settings may not be optimal (please give me tips!), but my basic settings are as follows:

Layer height: .1mm

Print speed: 40mm/s

Printing temperature: 195  C

Bed temperature: 60 C

Platform adhesion type: Raft w/ .22mm air gap

Retraction speed: 50 mm/s

Retraction distance: 4.5mm

Initial layer thickness: .3mm

Travel speed: 70mm/s

Bottom layer speed: 15 mm/s

Infill speed: 70 mm/s

Top/bottom speed: 30 mm/s

Infill: 3% (for added support when printing the top layer)

*All other speeds are the same as the print speed*

These settings seem pretty obvious to me, but being new to the 3D printing hobby I want to assist other new member with printing successfully!

BE ADVISED: this print took me 16 hours and 40 minutes to print with my given settings!