settings i printed this are as follows:
Cura newest version
quality 0.2mm
initial layer height 0.3mm
wall/top/bottom thickness 1.0mm layer count 6
infill 15% cubic
material is inland PLA white
temps
extruder 210 C
bed 65 C
retraction enabled
speed 100mm/sec 120mm/sec travel speed
infill 100mm/sec
wall 50mm/sec
cooling enabled support everywhere and a brim of 22 lines for adhesion
Loading prints...
A8 E3d V6 bowden carriage with sensor mount front anet a8
3
likes
2
collections
Tags:
Creative Commons Attribution
You can distribute, remix, adapt, and build upon the material in any medium or format, as long as attribution is given to the creator.
Licensed under CC BY
Loading comments...