Pablo Gonzalez

@Pablo Gonzalez

Joined August 2017

5 Designs

0 Followers

0 Following

Designs

i printed it at a layer height of 0.18mm with support only touching the build plate on a 0.3mm ra...

25 ❤️ 4 💬 -2 ⬇️ Free

this is a holder or placard for the sunshine state toll Pass sticker decal, that is mea...

0 ❤️ 1 💬 0 ⬇️ $0.5

i remixed a design of a square smaller version of this and made it longer. print setting are in t...

1 ❤️ 2 💬 -2 ⬇️ Free

I saw this designed on thingiverse and loved it but when i printed it it was off center and the f...

10 ❤️ 1 💬 -2 ⬇️ Free

settings i printed this are as follows:Cura newest versionquality 0.2mminitial layer height 0.3mm...

3 ❤️ 2 💬 0 ⬇️ Free