Rostock Max Effector Platform - Fan Shroud Combo
SummaryI designed this effector platform to hold three 30x10mm blower fans. The part is hollow on...
USBAsp Cover V2
SummaryThis is a cover for a USBasp AVR programmer http://www.fischl.de/usbasp/ I found a nice, s...
OmniMac Vibration Ball - Silicone Mold
SummaryThis mold is part of my 3D Printed QuadCopter project. Check out all of the files and a bu...
Rostock Max Lightweight Belt Clamp
SummaryI designed this belt clamp to clip under the standard plastic arm mounts on the carriage. ...
Low Clearance Rostock Max Fan Duct
SummaryI designed this duct because the "stock" ducts from Guanu, John, and HeathenX wouldn't fit...
SeeMeCNC EZStruder Upgrade
Summary This is my own redesign of SeeMeCNC's EZ Struder. I designed it to have a tighter filamen...
Headphone Hook - 19mm Desktop ( Ikea Bjursta )
Summary I modified the original design to fit my 19mm Ikea Bjursta desktops. The tops actually me...
ShapeOko II Outside Belt Clamp - Add an inch of travel to your O
Summary I designed these belt clamps to mount to the outside of the plates on my ShapeOko II and ...
E3D Heater Block Micro Z-Probe
Summary I designed this bracket to snap on to an E3D-V6 heater block and to hold a tiny microswit...
Tubing Cutter - One Piece Guillotine
Summary I created this part to be a cutter for small tubing like aquarium hose and bowden tubes. ...
5mm motor to 8mm pulley adapter
Summary I created this adapter sleeve so that I could use 8mm GT2 Pulleys with stepper motors tha...
Repaired Raspberry Pi B+ Retro Case. Repaired original files, ma
Summary The original base unit has several holes and multiple shells. I removed the extraneous ge...