Taco shell holder
by Johan F
Holds two taco shells. Prints as is with support. Preferable in ASA or PETG to stand better with ...
Dual Spoolholder for Creality CR-10 or similar
by Johan F
It needs some metal bending and that needs heat. It is extremely rigid and can be printed with P...
Dual Extruder for CR-10 (side by side version)
by Johan F
This is the side by side version of my dual extruder set up. the other two, https://www.thin...
Filament end Switch
by Johan F
A simple end of filament switch based on the switch that is standard on the Creality CR-10. I con...
Bracket for 3DTouch Probe on Creality CR-10
by Johan F
Summary This is for mounting the 3DTouch alignment probe on the printer head. One do need to chan...
Vibration damper for Flight Controller
by Johan F
Summary Made this as vibration dampening for controller card. Its just a couple of "cups" with a ...
Hot wire tensioner for CNC hot wire cutter
by Johan F
Summary This is a tensioner for the wire so it can change length and still have the same tension....
Hot Wire Cutter Tensioner V2
by Johan F
Summary This is a variant of the other tensioner I made for CNC hot wire cutter. It doesn't build...
Tool holder for Creality CR-10 standard tool set
by Johan F
Summary Another tool organizer for the oem tool set that comes with Creality printers. It is supp...
Enclosure for Raspberry Pi 3 and Creality CR-10
by Johan F
Summary This is an enclosure that is fastened with screws throw the grid at the side of the contr...
Dual Extruder for CR-10
by Johan F
Summary This is now the final version, probably. From here there will only be minor changes if so...
Voltage through cable isolation tester
by Johan F
Summary This is an simple device used to check if a cable is live or not. It is a quick way to fi...