Lada 2104 Cookie Cutter
by alexandr_sk8
Summary As a basis took a photo of my first car. I print this with PLA Print Settings Printer: Cr...
Lovely curly sheep
by alexandr_sk8
Summary This decision was spontaneous. My wife saw similar on the Internet and and said - I want...
Fine Ajustment Z Endstop for Anet A6
by alexandr_sk8
Summary Alternative attachment for Z endstop for my printer Anet A6. I decided to do it when I st...
Power Supply cover Anet A6
by alexandr_sk8
Summary I publish my version of the power supply cover for the 240w Anet A6. All the covers that ...
Wire Clip
by alexandr_sk8
Summary I ran out of clips that I bought in the store, and they urgently needed it. I measured th...
M3 nut Knob (Alternative for Anet A6)
by alexandr_sk8
Summary I decided to replace the standard nuts securing the table to the nut with nylon. A wrench...
Holder for Remote controller
by alexandr_sk8
Summary I typed it in "Vase" mode. Nozzle size 1.0, layer height 0.3. You can make the height of ...
Flower Pot for Succulents
by alexandr_sk8
Summary Very nice pots for succulents. I print with PLA, infill 30%, nozzle size 0.5 Print Settin...
Square Flower Pot for Succulents
by alexandr_sk8
Summary Just another square nice pots for succulents. I print with PLA, infill 30%, nozzle size 0...