Graham Daniel
@Fluidity
Modern jack of all trades from inventing, 3D design, embedded programming, computer programming to electronics design.
Tubercles hydrofoil, high aspect 1260sqcm
by Fluidity
This is a high performance wing I designed late 2021 and that I printed, moulded and have be...
Flat panel speaker hangars
by Fluidity
Designed to be glued into extruded polystyrene sheet to hang them with the weight of attached exc...
Riser tube for ANKO food dehydrator
by Fluidity
Save the dehydrator trays in the ANKO food dehydrator and instal a 159mm riser to carry your fila...
Recessed handle for foam core wing foil or wind surf board
by Fluidity
The foam dents from finger tip grips so I designed a load spreading handle for the new foil...
UnifoilXfast 1400sq CM for wing foiling
by Fluidity
Tentative design for my third working hydrofoil for wingsurfing.
Manta Ray Gull wing unifoil.
by Fluidity
I'll likely be CNCing this from 50mm EPS foam. Designed for a rider around 100KG for slower ...
Gaping limpet Foil SUP grab handle
by Fluidity
As an alternative to my other underneath SUP grab handle. Best printed in TPU. The diminsions sho...
Inflatable foil SUP grab handle.
by Fluidity
Print to max 0.2mm height for 0.4mm nozzle, min 3 layers walls, 6 top, bottom layers, minimu...
Inflatable SUP planing kit.
by Fluidity
Print in a TPU like Ninjaflex or similar, 0.3mm layer height, 20% cubic infill and clean up with ...
Inflateable SUP, Foil SUP planing wedgies
by Fluidity
If you run a stream of water over the under side of a spoon that jet of water curves to follow th...
Openfuse: Hydrofoil main fuselage body.
by Fluidity
This is a work in progress, aim is to have a fuselage compatible with many wings and masts. this ...
Fluidity Wingsurfing hydrofoil
by Fluidity
This is not a NACA wing. The profile and surface is independently mathematically created with a v...